INA bearing is a subsidiary of schaeffler group, Germany's INA bearing company, founded in 1946 and headquartered in nuremberg, Germany. Germany INA shaft company since its inception, has been committed to product innovation, to meet customer needs, a
This product is used in the shell of the microphone. It belongs to the outer decoration device. It is equipped with electrical components, microphone components, wires and other accessories.
Designing a good aluminum die casting mould involves several factors, including product geometry, material selection, draft angles, and gating system design.
Micropore tape is a type of medical adhesive tape widely used in surgery. It is used to seal the incision site and provide protection to the wound site. The tape is made of a porous material, allowing air and moisture to pass through, while still keeping
Diode laser hair removal comes with 808nm wavelength laser stack or 755+808+1064 triple wavelengfth laser stack with semiconductors technology. They are assembled together to produce light for permanent hair removal/hair reduction/depilation/epilation tre
1. Mould material: S50C, P20H, 718H, 2738, S136 and etc.2. Cavity no.: single or 1+13. System of runner: hot runner, cold runner4. Ejection type: ejection pin, air gate, hydro cylinder5. Term of mould production: 50days---60days
Sparkling and Elegant look earrings for women and teen girls, can be worn daily. Crafted of 925 sterling silver polished finish tarnish free and nickel free.
The FAL Pneumatic vibrators have Aluminum shell, corrosion resistant, with special grease; the piston rod outside the shell vibrates with the piston; long life guarantee, to adapt to different applications And the frequency and vibration amplitude is adju
Thanks to these machines,we are equipped to work with a wide range of thicknesses from 0.2mm up to 20mm, for sheets with a maximum size of 1500×3000mm.
Model: TW-GM12 SeriesClassification:Spur DC Gear MotorApplication:Automatic door lock, projector, hairdressing equipment,Etc Notes: The motors can be designed according to customer requirements
The graphite electrode produced by our company is made of high-quality petroleum coke, needle coke, coal tar pitch and other low ash raw materials. After being calcined, batched, kneaded, shaped, roasted and pressure impregnated, it is graphitized at a te
Since the density of magnesium alloy is 1.8/cm3, its weight is very small. The parts of magnesium alloy have the following characteristics: light weight, high strength, high rigidity, good heat dissipation, greater ability to bear impact load than aluminu